Give each supplier the same visible evidence
Send one picture of each side of the doorway and any measurements you can label clearly. State whether your tape touched the current slab, the inside of the frame or two visible edges outside it. If you can only measure around the casing, label that as trim. Do not make a rough opening by subtracting a guessed trim width.
Tell the supplier which parts conceal the true edges and what you want to keep. Ask whether they can advise on candidate units from this evidence or whether they need a site check before discussing fit. Record whether a quoted size is a comparison assumption rather than a confirmed order specification.
- Make a list of unknowns instead of filling them with approximate allowances.
- Use the same photos and numbers with both proposals.
Compare how the unknowns will be resolved
Ask each provider what they will verify and when. If an estimate assumes a particular frame or opening condition, ask what would happen if it is different once someone can inspect it. Do not order based on a preliminary size that has not been checked.